電變/控有問題

我想問下點先可以教到架車有前無後?又唔會自動brake?

有前無後係唔係係正路會快d嫁

我用既係Futaba MC330CR,定係係個控到較?

燒焊油門就可以有前無後 , 又唔會自動brake , 從無縮油何來正路會快d嫁

原帖由 老夫子 於 2007-5-19 18:57 發表
我想問下點先可以教到架車有前無後?又唔會自動brake?

有前無後係唔係係正路會快d嫁

我用既係Futaba MC330CR,定係係個控到較?

呢位哥仔想講乜呢?
唔想要BRAKE,按住個MODE制開ON/OFF,咪會熄咗個後波囉!

熄咗同唔熄個電變速度都一樣!唔會話熄咗後波個電變會令你摩打快咗!

無縮油無制動咪會快d囉

我其實想問既係,MC330CR有無得教到無後波
同埋無後波,向前行既時候係咪會快d

唔該哂2位

原帖由 老夫子 於 2007-5-19 18:57 發表
我想問下點先可以教到架車有前無後?又唔會自動brake?
有前無後係唔係係正路會快d嫁 I think no.

我用既係Futaba MC330CR,定係係個控到較?

you should read the instruction mannual http://manuals.hobbico.com/fut/futm0932-manual.pdf .

又有第2個問題黎la.......我個摩打成日唔識行,換完碳擦都係咁
比油個電變有燈,但摩打唔行......

[quote]原帖由 老夫子 於 2007-5-19 07:36 PM 發表
我其實想問既係,MC330CR有無得教到無後波
同埋無後波,向前行既時候係咪會快d

You can see the setting in the Futaba  Manual.
*Just press the ESC buttom Hold.......then switch on the power, OK.

Your motor cannot move may be the Gear ratio problems( the pinion gear cannot set too tight or too near the Spur gear, just keep a little bit gap for them......and what motor u using?

If you use 330CR + Tamiya super stock motor without any problems!

I'm not professor here, Your have the problems now I also get before !!!