點解裝完個Stablizer架車冇咗回彈力???

未裝之前架車壓低咗 (用手"禁"低佢) 都有回彈力(用硬彈弓).....

但點解裝完後架車回彈力弱咗好多???

(借圖一用)

[ 本帖最後由 bigben 於 2007-9-7 10:53 編輯 ]

Buggy no need that one la.....


*** for 1/10 Touring is ok.

[ 本帖最後由 raymen 於 2007-9-7 12:07 編輯 ]

i know....
but someone say that it is better for steering and more stable....if the car body is set to be high.....

你架係乜車嚟先？

Have you tightened the hex screws for holding the bar in place?

你架係乜車嚟先？ ------- Kyosho GP buggy

Have you tightened the hex screws for holding the bar in place? ------ Yes

It could be the angle or the bar is too stiff. So the car cannot bounce back.

After you pushed the car down, the car stuck at that position and won't bounce back.

But if you use a finger to slightly push the car upward, at certain point, the car will bounce suddenly. Then the Bar is not set properly.

Try adjusting the 2 bar holders (at the end of the bar) slightly and try again.

原帖由 i-Drift 於 2007-9-7 13:08 發表

                               
登錄/註冊後可看大圖

After you pushed the car down, the car stuck at that position and won't bounce back.

But if you use a finger to slightly push the car upward, at certain point, the car will bounce suddenly. T ...

how to adjust..... ??

actually, I tighted the hex screws when the four wheels are off the ground..... is it correct?

原帖由 bigben 於 2007-9-7 13:17 發表

                               
登錄/註冊後可看大圖

how to adjust..... ??

actually, I tighted the hex screws when the four wheels are off the ground..... is it correct?

The mount that holds the anti roll bar should be adjusted so that the whole suspension falls freely without the shocks installed.  Remove the shocks from the lower suspension arms, and adjust the set screws that hold the anti roll bar.