DIY-Awd 改(己加bumper)

Brushless is very possible.

原帖由 billy86che 於 2007-12-11 00:47 發表

                               
登錄/註冊後可看大圖

Brushless is very possible.

整到無刷仲正過個中軸差速, 期待

it can be done buy just buying the motor....but the worst thing is we have to still keep the motor at the higher position as we still need the room for improvement...

i have successfully lower down the motor for 2mm.......
i know this is not a great change, but anyway...i can't think any good solution....

Evolution should be done at the stage of having a satisfactory performance. Revolution is what you need now. (擰擰頭)

i know...
do you know where can i get a 130 brushless motor?
i have searched in the website....but can't find any place in hk.

i want to ask 老師too
Have you seen the abc 1/24 rc?
they put the motor on the top too..... can i just follow to do that?

What's so great copying a car that no one wants?

There is no brushless 130 but there are motors of similar or smaller sizes. Go to Wai xx (Wxx go) to find them. The problem lies on the 'non-reversible' ESC.

there is 130 brushless.
i have searched it , but it was sold in mainland china...
the esc is a problem too..

老師, even thought i put the motor down, the electronic stuff will at the same height too....
how can i improve this?

Smaller cells, smaller receiver, smaller... but bigger body shell, wider offset, give up the original body clips on both sides...

i have give up the original body clips...
smaller cells...use lipo...but charger(quite expensive....)
smaller receiver... do it have am receiver?
........

原帖由 deadmatch 於 2007-12-11 23:19 發表

                               
登錄/註冊後可看大圖

i have give up the original body clips...
smaller cells...use lipo...but charger(quite expensive....)
smaller receiver... do it have am receiver?
........

u can go with a e-sky balanced Lipo charger if u want, selling for under $100 out there.

as for the batteries, u may consider these AAA sized Li-ion if u think Lipos are too complicated.

i used them on my mr015, all i had to do is rearrange the wires to form a 2S2P config.

Ultrafire is reported to have at most 310mah @.

then, which brand should i use?

No other aaa is worth trying at this moment. You can of course try the ultrafire and 玩一陣 every time.

我have tried the ultrafire in my diy 02 too>
it can work for 1 hrs....

原帖由 deadmatch 於 2007-12-12 17:41 發表

                               
登錄/註冊後可看大圖

我have tried the ultrafire in my diy 02 too>
it can work for 1 hrs....

aaa size?