Tamiya TEU101 for 4WS?

Is the TEU101 enough for powering two high torque servos?
like futaba 9451 or bluebird 630MG?
I would like to make a 4WS system for my ax10

There is no BEC circuit inside TEU101. So the "red plug" of TEU101 is directly connected to the battery supply e.g. 7.2V.  This question then goes to whether the power provided by the BEC circuit (if any) of your receiver is enought for powering two servo.

原帖由 ryancmlam 於 2007-12-27 01:18 PM 發表

                               
登錄/註冊後可看大圖

There is no BEC circuit inside TEU101. So the "red plug" of TEU101 is directly connected to the battery supply e.g. 7.2V.  This question then goes to whether the power provided by the BEC circuit (if  ...

ｕ　need to add ext. BEC for your servo
Today ,Most of the receiver haven't built in bec ....
some receiver still have it but basically it is a current limiter by using a single transistor to limit the current .That is  not enough for two of your high power servo...

[ 本帖最後由 ice1234 於 2007-12-27 13:34 編輯 ]

Thanks brothers for answering
how can I determine the power of the BEC I need?
besides, I'm just using a 2-channel receiver, so I need a "Y" cable to divide the servo channels
will this be any problem?

原帖由 ice1234 於 2007-12-27 13:33 發表

                               
登錄/註冊後可看大圖

ｕ　need to add ext. BEC for your servo
Today ,Most of the receiver haven't built in bec ....
some receiver still have it but basically it is a current limiter by using a single transistor to lim ...

Bro ice, I like your photo!!