Mini-Z MA010 Low-Down Type Suspension Set

I bought the Mini-Z MA010 Low-Down Type Suspension Set, however, those spring are shorter than the original spring.  If I insert those new and shorter springs, it seems those springs are too short to be functional? Am I supppose to put those spring elsewhere?

http://www.pnracing.us/new/product.php?show=product&id=237

These springs are shorter than the original ones so that you can have a lower ride heigh. Therefore, if you use these springs, you need to sand away the proturing sections on the bottom of the chasis, so that they wont be rubing against the carpet/floor.

原帖由 kayipchan 於 2008-9-5 19:19 發表

                               
登錄/註冊後可看大圖

I bought the Mini-Z MA010 Low-Down Type Suspension Set, however, those spring are shorter than the original spring.  If I insert those new and shorter springs, it seems those springs are too short to  ...

You need to put spacers that came with the car onto the pin which is beneath the king pin.

Actually, I am using the metal cover with swing bar now for both front and rear cover, should I add more spacers as well???

Also, where is the proturing sections???

Many thanks  

原帖由 kayipchan 於 2008-9-6 01:51 發表

                               
登錄/註冊後可看大圖

Actually, I am using the metal cover with swing bar now for both front and rear cover, should I add more spacers as well???

Also, where is the proturing sections???

Many thanks  

The pin infront of the one that goes into the toe-in bar.