Slash 4x4 stock motor

Any ching have a manual for the stock motor for slash 4x4 ? The motor manual in Trax website is difference, it indicate able to remove both end for changing bearing, but the one actually on hand cannot remove the shaft end (pinior gear side). My motor bearing crash today but not able to take iot out for repair...

登錄/註冊後可看大圖

啲啤令散晒

試試把整個摩打心放入冰格雪2-3小時，之後一邊旋轉一邊用火機燒個啤令心（注意盡量不要燒到摩打軸）燒到咁上下用鉗把啤令心拔出來。
希望幫到你，但不擔保必定得。

電波好似有此摩打修護套裝買,印象中大約一百蚊。
但此摩打好像不及teampower的3700kv540好,teampower那隻540省電很多

回復 4# ThomasZ


    終於有c hing 勁過u.......你最多死gear

磨機''飛"一下就甩 ... 或用鑽石銼慢慢銼 ... 但如果你無工具就買個新摩打算了 ... 呢個可能係玩水戰既代價 ...

電波好似有此摩打修護套裝買,印象中大約一百蚊。
但此摩打好像不及teampower的3700kv540好,teampower那隻5 ...
ThomasZ 發表於 2010-9-26 21:25

                               
登錄/註冊後可看大圖

ching, 修護套裝 is not necessary, just change the bearing is enough ( HK$20 maximum ), but the question is not able to take the damaged bearing out, the inner bearing ring is on the shaft, the outer bearing ring is in the motor housing. Manual and Trax website indicate the motor has screw on both end and can take off both end cap for changing bearing, but actually the motor has no screw on shaft end and I cannot take the bearing off the case....I wonder if there is difference version of tye stock motor ??

Team Power's 540 water proof or  not ??

登錄/註冊後可看大圖

回復 7# gimsink

我都唔知防唔防水, 但聽人講所有摩打(除了有感)都防水

爆bearing 通常都係咁既情況!我novak HV 同TRX motor 爆過5-6次!! 支rotor 用鉗夾實個bearing 圈狠心小小大力挫就整到出黎!!

motor 蓋就煩d ! 要兩個人一人一支一批+槌仔! 平衡地交差式一下一下同時打bearing 圈既兩邊整佢出來

唔洗放棄motor 同rotor !! 因為咩motor 爆bearing 都係咁食住, 買返d 優質bearing 就ok !

回復 10# tatame

米師兄請問有無試過用4x4套無刷放落架e-maxx到夠唔夠力推?

回復  tatame

米師兄請問有無試過用4x4套無刷放落架e-maxx到夠唔夠力推?
ThomasZ 發表於 2010-9-27 14:57

                               
登錄/註冊後可看大圖

540 應該唔夠力~~ 一係用Vtwins ! 玩兩隻XD ~ 不過用一隻550 /600 好過la !

                               
登錄/註冊後可看大圖

http://www.youtube.com/watch?v=cJWWBCgAOio

回復 12# tatame

我架係summit, 應該用唔到vtwins?
請問550/600 有咩好推介?

爆bearing 通常都係咁既情況!我novak HV 同TRX motor 爆過5-6次!! 支rotor 用鉗夾實個bearing 圈狠心小小大 ...
tatame 發表於 2010-9-27 10:30

                               
登錄/註冊後可看大圖

米師兄, thank you for your advise. Ofcourse I will not give up my motor, otherwsie I just buy one and no need to ask all ching's help. Will try as what you said.
Also, the stock motor is longer than normal BL ( around 56mm vs 46mm ), so is it not powerful enough when i install a standard 540 size BL motor to 4x4 ?

Also, I reconized that there are some BL motor on sale in RCmart, prices are good, just around US$50 :  
Speedpassion V2 11.5T
LRP vector X11 4.5T
Are these motor OK to use with Slash 4x4 ?
If Ok then I want to buy one as backup ....

回復  tatame

我架係summit, 應該用唔到vtwins?
請問550/600 有咩好推介?
ThomasZ 發表於 2010-9-27 21:19

                               
登錄/註冊後可看大圖

hobbywing 150a 有感