差電機差2A/3A電問題...

我家有下圖那部差電機...
請問一下可以用來差2A/3A電嗎?

                               
登錄/註冊後可看大圖

以下是一些資料
BOL Flame Charger
Features:
-High Speed sample rate negative delta voltage and zero delta voltage auto-detect cut off circut with MOSFET control for peak detection. Pulsation charge method to prevent overcharge and overheat.
-Charge Ni-MH battery by aero delta voltage technogy without using thermo-detection probe.
-Auto-detect switching mode charge for Ni-CD and Ni-MH battery.
-Front panel with MODE buttons and dial to switch between Charge, Discharge, 1 Cycle and 3 Cycle
-Reverse polarity protection system
-Charge battery pack with 1-8 cells
-Auto detect system for power input 110-220V AC or 12V DC
-Build in 5A discharge device for single or cycling discharge

Specification
Input Voltage: DC 10V - 16V ( Charger ) AC 100V - 240V ( Power Supply )
Battery Voltage Range: 1.2V to 9.6V
Charging Current: 0.5A to 7.0A
Discharging Current: 5A

先謝解答~

可以,買個果O的2A或3A O既電盒仔放落去嚟差電都OK.
記得較返O的幾多CELL,同埋唔好太大A數嚟差就OK.

多謝解答~

我昨日試了...電池盒都'辣'熔左...好在見到jar...

原帖由 ballballkau 於 2006-9-24 02:59 發表
我昨日試了...電池盒都'辣'熔左...好在見到jar...

幾多 A 义呀.

原帖由 ballballkau 於 2006-9-24 02:59 發表
我昨日試了...電池盒都'辣'熔左...好在見到jar...

ballballkau大都用這差機嗎?
這差機好像沒有cell數調較的...不知是否這問題...

應該係A數SET得太高 , 差2A或3A電, 用1A電流差就安全D

[ 本帖最後由 AlexFiona 於 2006-9-24 19:24 編輯 ]