FF01 Upgrade with 416 Front Suspension

With new Front Suspension, you no need to worry about the vintage Spare Parts

Ching, how to mount the battary? In addition, is front wheel distance great than rear wheel?

唔使咁喎，我賣包原裝臂比你丫

好法子

回復 felita 的帖子

use the brecket which from TA02 FRP upgrade kit, then u can use both stick batt or lipo

回復 hihizaza 的帖子

haha, l don't like the short A arm, most important is that the new CVD's quality is much better than the old one

no doubt the new CVD has better tolerance than the older one

DIY graphite chassis ??

我已為頭尾都改埋添

minimini 發表於 2012-3-18 00:37

                               
登錄/註冊後可看大圖

DIY graphite chassis ??

I also have the same question

minimini 發表於 2012-3-18 00:37

                               
登錄/註冊後可看大圖

DIY graphite chassis ??

TAMIYA TA02 original Carbon plate kit.
Next Step is DIY a Carbon Chassis & upper deck to use 416/417 Rear Suspension
......
Then, The car just look like FF03,haha...

HOw can you do it?

Can you give some hints to me?

Thanks a lot

個尾改到咁神化
比相睇下先得架

回復 pkmarc 的帖子

If you have both 416 Frt Suspension arm and FF01 Chassis, just measure the width of that conection, only widder 1mm, so ,just remove some material of 416 arm, then you can use it!
Use the original PIN is fine.
About the upper link, also use the original hole on the shock tower

BTW: Must use 44mm dog bone. 46mm is too long.

thanks a lot

Any Spare part of bumper
Any other part to replace the damaged bumper