Wiring connection for Vintage KO PS-1001FET servo

Hi, Anyone know how to connect the wiring of that servo ?

From the servo, i find 1 single blue wire, is it connect to the signal output from receiver or can i combine with the blue wire of the servo plug ?                        

Thanks a lot

登錄/註冊後可看大圖

最好駁到同樣有藍色線的舊式變速，如Novak的410M1c,410Mxc,如不能的話駁到servo插的正極也可

你圖中駁法有點奇怪，好像駁到訊號線

我cut左藍色線直接拆殼駁入+極便可

The blue wire is for power of the motor inside the servo. It can connect to voltage higher than 6V ( from the receiver). It can be 7.2V, 8.4V or 9.6V to increase the speed of the servo. This wire is use to separate the power of the servo motor to the control signal. You should not connect to the blue wire of the original servo cord as it will cause short circuit. You can only connect to the red wire of the sevo cord but it will slow down the speed of the servo as the input voltage is 6V only. Masami use 2 additional battery ( small size ) for the steering servo ( the first KO FET servo ) to speed up the servo when he win his first world title.

Thank you all Ching valuable RC experience !
Thank you so much.