question in brushless system

I just finished reset the novak 4.5r brushless system, when neutral, the red, green and amber leds are all on.  Is it normal?   Thanks

                               
登錄/註冊後可看大圖

[ 本帖最後由 gibson 於 2007-2-6 01:47 編輯 ]

If you use drag break setting, two lights will be on which is normal, not just one light as stated in the manual. But I don't remember which colour should be on at this moment.

原帖由 007 於 2007-2-6 12:03 發表
If you use drag break setting, two lights will be on which is normal, not just one light as stated in the manual. But I don't remember which colour should be on at this moment.

I had read all the manual but did not mention about the lights wor...

Gibson, see the flow chart in page 6 of your manual; you will see the light is written inside each box.

原帖由 007 於 2007-2-6 12:20 發表
Gibson, see the flow chart in page 6 of your manual; you will see the light is written inside each box.

Thanks 007, will check again!!