RC EVOLUTION - 遙控工房 - 香港RC遙控車討論區

 找回密碼
 新玩家註冊
搜索
查看: 23320|回復: 15
打印 上一主題 下一主題
收起左側

潛水 Q&A

[複製鏈接]
跳轉到指定樓層
1#
ryancmlam 發表於 2007-9-18 20:41:19 | 只看該作者 回帖獎勵 |倒序瀏覽 |閱讀模式

遊客登錄

您需要 登錄 才可以下載或查看,沒有帳號?新玩家註冊

x
Just want to share our "discussion" in the TKO offroad party regarding 潛水. Pls feel free to correct if I am wrong.

Q1. What is 潛水 ?
A1. rx 同 Tx 對掉就o.k. 也叫做潛水.

Q2. 我rx同tx一樣樣, 冇分ga wor?
希望可以簡單explain一下。
一般RC系统的接收晶体(Rx)的frequency是比發射晶体(Tx)低0.455Mhz的。e.g. If Tx is 27.145Mhz, Rx would be 27.145-0.455=26.69Mhz(note:印刷在Rx上的數字是說明它是配合那個Tx,不是說它本身的frequency,你可看看刻在晶体的數字)。但是一般簡單(非貴價)RC系统的接收機也會同時解讀比Tx高0.455Mhz的訊號e.g. If Tx is 27.145Mhz而接收機的晶体是27.145+0.455=27.6Mhz的話,整個RC系统也可運作。Similarly,若你的發射晶体是26.69Mhz,而接收晶体為27.145Mhz(即"潛水"),整個RC系统也可運作

Q3. 我的band is AM 27.195 ,如果玩"潛水", TX 便變成 26.740,但是車的RX變成 27.195,那麼Receiver是不是會同時受到 "27.195 or 27.650 Controller" 的控制 ?

A3.If the crystal in your receiver is 27.195 Mhz.
- It will NOT be controlled by a transmitter with Tx = 27.195, but
- It will be controlled by a transmitter with Tx = 27.195+0.455=27.650Mhz and by the side-band i.e. Tx=27.195-0.455=26.740Mhz.
So Receiver是會同時受到 27.650 and 26.740 Mhz Controller 的控制

Q4. 點解Rx要比Tx低0.455Mhz的 ?

A4. I try to explain it in a simple way.
Transmitter的訊號頻率e.g.27.145Mhz是指"載住"控制訊號的頻率。而控制訊號本身的頻率通常底於27.145Mhz很多。在Transmitter運作時,它會把"控制訊號"加進"搭載訊號"(=27.145Mhz)頻率中而成為發射訊號。當receiver收到發射訊號後,它會利用本身crystal的頻率(26.69Mhz)把搭載訊號從發射訊號減走,取得控制訊號。非高價receiver通常冇分走負數,因此正負都要i.e.(26.96+0.455=27.145Mhz) or (26.96-0.455=26.235Mhz)也同時被當作發射訊號。
2#
gibson 發表於 2007-9-18 21:01:18 | 只看該作者
Very informative!!  Can put on the top list!!  
3#
ice1234 發表於 2007-9-18 21:28:55 | 只看該作者
唔係對對band都係差455khz
好似fm咁
有分dual conversion同single conversion
前者晶體頻率差10.7mhz...如果發射係27.195mhz,接收高放電路先將收取得來的27.195mhz經phase lock loop circuit,加入local oscillator整出來的16.495mhz(接收晶體),signal經 mixer同filter 選出10.7mhz,經中放電路放大再係mixer加入local oscillator整出來的16.04mhz(內置接收晶體)SIGNAL, signal經 mixer同filter 選出455khz,再經中放電路放大到......低放.......最後decode

single conversion (同am一樣)
如果發射係27.195mhz,接收高放電路先將收取得來的27.195mhz經phase lock loop circuit,加入local oscillator整出來的26.74mhz(接收晶體),signal經 mixer同filter 選出455khz,經中放電路放大到..........低放.......最後decode

其他野都係唔o係度講...講左都無人知咩離

[ 本帖最後由 ice1234 於 2007-9-19 10:45 編輯 ]
4#
 樓主| ryancmlam 發表於 2007-9-18 21:37:09 | 只看該作者
原帖由 ice1234 於 2007-9-18 21:28 發表
唔係對對band都係差455khz
好似fm咁
有分dual conversion同single conversion
前者晶體頻率差10.7mhz...如果發射係27.195mhz,接收高放電路先將 ...


Yes. That's why I bold "非貴價". i.e. single conversion.

Dual conversion system shoud not 潛水 (in fact, cannot). Am I right ? (I just guess and didn't try before, of course, haven't check the reference book)

BTW, do you know which model of RC receiver is dual conversion ?

[ 本帖最後由 ryancmlam 於 2007-9-18 21:44 編輯 ]
5#
gibson 發表於 2007-9-18 22:02:18 | 只看該作者
Can it be more "complicated in, simple out"     thanks!

6#
ice1234 發表於 2007-9-18 22:11:24 | 只看該作者
原帖由 gibson 於 2007-9-18 10:02 PM 發表
Can it be more "complicated in, simple out"     thanks!


電子野正是那麼complicated ...
7#
蒙古殺手 發表於 2007-9-18 22:43:00 | 只看該作者
thx ryan
簡單一句
fm 無得潛水
8#
 樓主| ryancmlam 發表於 2007-9-18 23:00:25 | 只看該作者
I think it could be if the FM is a single conversion system. However, I don't know and haven't checked. I just know that AM is, because of .... cheap....
9#
老人家 發表於 2007-9-18 23:33:14 | 只看該作者
好!絕頂玩車冷知識
10#
ice1234 發表於 2007-9-20 10:54:32 | 只看該作者
原帖由 ryancmlam 於 2007-9-18 11:00 PM 發表
I think it could be if the FM is a single conversion system. However, I don't know and haven't checked. I just know that AM is, because of .... cheap....


YES,only AM and FM  single conversion system can use  潛水  ,because the unwanted image signal is so closed to wanted signal(only 910khz),it is difficult to filtered out of this unwanted signal ,however if u swap RX AND TX ,the efficiency of RC system will be reduced.

FM dual conversion system can't swap their RX TX,because of the unwanted is so far away from the wanted signal ("21.4mhz"), it can easily to filtered out of this unwanted signal by using suitable filter.Thus,FM dual conversion system can't swap their RX TX.

BTW, some "非貴價" like E-SKY ($120) , they also develop their FM receiver  based on dual conversion type.

[ 本帖最後由 ice1234 於 2007-9-21 11:42 編輯 ]
11#
 樓主| ryancmlam 發表於 2007-9-20 23:36:32 | 只看該作者
原帖由 ice1234 於 2007-9-20 10:54 發表


YES,only AM and FM  single conversion system can use  潛水  ,because the unwanted image signal is so closed to wanted signal(only 910khz),it is difficult to filtered out of this unwanted signal ,h ...


Probably my knowledge is out of dated now. How come a cheap cheap Esky receiver could be dual conversion....
12#
ice1234 發表於 2007-9-21 11:24:55 | 只看該作者
原帖由 ryancmlam 於 2007-9-20 11:36 PM 發表


Probably my knowledge is out of dated now. How come a cheap cheap Esky receiver could be dual conversion....







http://www.rc711.com/shop/produc ... amp;products_id=189

[ 本帖最後由 ice1234 於 2007-9-27 10:50 編輯 ]
13#
Panda 發表於 2007-9-21 11:41:13 | 只看該作者
收音機 :
AM    I.F. Frequency : 455KHz
FM    I.F. Frequency : 10.7MHz

RC :
AM   I.F Frequency : 455KHz
FM ( PPM & PCM )   I.F Frequency : KO , Futaba , SANWA ,JR 間間厰都不同 . PCM 同 PPM 嘅 I.F. 都唔同 , 若果相同嘅話的 X'TAL 可以撈亂用啦但事實上用唔到吖嗎 ..............
14#
ice1234 發表於 2007-9-21 11:50:19 | 只看該作者
原帖由 Panda 於 2007-9-21 11:41 AM 發表
收音機 :
AM    I.F. Frequency : 455KHz
FM    I.F. Frequency : 10.7MHz

RC :
AM   I.F Frequency : 455KHz
FM ( PPM & PCM )   I.F Frequency : KO , Futaba , SANWA ,JR 間間厰都不同 . PCM 同 PP ...


Although, they have same IF frequency and same conversion ,FM transmitters are not always compatible with receiver from other manufactuter,as the frequency shift from a 0 to 1 can either be positive or negative..
15#
pskyng 發表於 2007-12-19 15:24:03 | 只看該作者
咁. 潛水有咩用..(rx 同 tx 對換插)?
16#
tiger1 發表於 2008-1-18 13:22:52 | 只看該作者
Dual conversion, what is the advantage over single conversion?
您需要登錄後才可以回帖 登錄 | 新玩家註冊

本版積分規則

手機版|小黑屋|RC EVOLUTION - 遙控工房

GMT+8, 2024-12-11 03:32 , Processed in 0.129915 second(s), 15 queries , Gzip On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回復 返回頂部 返回列表