LRP Pulsar 3 充電

我用Lin 4.0A 义電時佢每5秒就會跳出Inp 12.2V,其實INP 12.2V係乜解哩?
問題二  當set  义机時個 D-Peak xxx mV,又係乜解哩?應該set 幾多?

登錄/註冊後可看大圖

I think the inp 12.2v = your power input.

D. peak = delta peak    depends on your batteries, if normal or new batteries, I will set it at 3mV.  This is to set the cut off peak.  If old batteries, I will set it at 4 or 5mV in order to get fully charge.  

This is only my own opinions!!

原帖由 gibson 於 2007-12-29 12:54 發表

                               
登錄/註冊後可看大圖

I think the inp 12.2v = your power input.

D. peak = delta peak    depends on your batteries, if normal or new batteries, I will set it at 3mV.  This is to set the cut off peak.  If old batteries, I ...

gib神兄,請問可謂 cut off peak 哩?

原帖由 mschumi 於 2007-12-29 13:04 發表

                               
登錄/註冊後可看大圖

gib神兄,請問可謂 cut off peak 哩?

This is the point of your battery if fully charged, it would sudden change, your charger is to catch this change to define your battery is fully charge or not.  If you set it too high, it may course over charge, if too low, under charge.  

So if your batteries are brand new or in good condition, set it at 3mv, if your battery could fully charged.  Keep it at 3mv..  This is my concept or the terms that I used may not be correct, but the principle is the same...  

Thanks!
gip神兄

I am gibson, not yet to become gib神!!  

yes sir