Question on DF-03MS

Hi:

I bought a DF-03MS. When I attached the gear case cover part M8 (this cover is used on DF-03 as well - it is to allow adding Slipper Clutch set) to M7 it was very loose - M8 kept dropping off.

Please advise how I can fasten M8 onto M7?

Thanks!

You need push and turn.

原帖由 li5115 於 2008-7-14 01:10 發表

                               
登錄/註冊後可看大圖

You need push and turn.

I was aware there were little humps in the inner part of M7. I did try to push and turn M8 but could not get the latch on M8 to slide over the little humps. What else can I do?

原帖由 tux 於 2008-7-14 10:30 發表

                               
登錄/註冊後可看大圖

I was aware there were little humps in the inner part of M7. I did try to push and turn M8 but could not get the latch on M8 to slide over the little humps. What else can I do?

Any inside view photo of M7?

原帖由 li5115 於 2008-7-14 10:50 發表

                               
登錄/註冊後可看大圖

Any inside view photo of M7?

I am busy today - will try to take some photo of M7 later tonight. It may be difficult to show the humps on the photos because M7 is black in colour ...

原帖由 tux 於 2008-7-14 12:00 發表

                               
登錄/註冊後可看大圖

I am busy today - will try to take some photo of M7 later tonight. It may be difficult to show the humps on the photos because M7 is black in colour ...

I got the Topcad Gear Case Cover and used the original M8 and it worked. (Could not use the metal replacement of M8 - doesn't fit )

DF-03MS幾錢?

原帖由 edmondhk 於 2008-7-17 00:03 發表

                               
登錄/註冊後可看大圖

DF-03MS幾錢?

$1,xxx

原帖由 tux 於 2008-7-17 00:11 發表

                               
登錄/註冊後可看大圖

$1,xxx

1001~1999?

原帖由 edmondhk 於 2008-7-17 19:03 發表

                               
登錄/註冊後可看大圖

1001~1999?

under 1500

原帖由 edmondhk 於 2008-7-17 19:03 發表

                               
登錄/註冊後可看大圖

1001~1999?

$1,4xx

原帖由 spoonbb6 於 2008-7-17 23:36 發表

                               
登錄/註冊後可看大圖

under 1500

13XX-14XX

thx all