ex-10慢爬4ws問題~

請問十仔點先可以前後反方向?用y插只可同方向.......有無師兄教路

後面隻servo有無位反轉裝?

點樣反轉裝?　　　　　　

有無師兄可以教下我......而家架野好似鬼咁打斜行支控又無鬼用無得set........

係咪即係尾個servo黑線插白線,白線插黑線咁?

You can try to use two servos from differental manufactureer. I had tried before in my TLT-1. I use MG995 at front and Sanwa(?) 577 at the rear side. Front and rear side turn at different direction. If you use the servos from the same make, it certainly will turn at same direction.
There are other methods from other C hing, some of them use the third channel to control. But it is not good, I think.

Sure not!White wire is data,red wire is +ve and black wire is -ve.
The servo have built in IC,Wrongly connect +ve and -ve will burn the servo!
You can try to instore the plastic servo arm up-side-down then the turning direction will reverse.
Hope this help.

但係我巳經有兩個servo係手~

明白喇.....即係只係將正負極掉轉就ok~
但係我又有野想問......就係點樣唔整爛個插頭而可以兩條線掉轉?
唔該哂各位~

http://www.gpdealera.com/cgi-bin/wgainf100p.pgm?I=FUTM4150

唔知ko o既產品用唔用到...

如果得就就唔使煩

我槍用ex10 servo就hitec hs7955tg同埋hs5645mg~唔知岩唔岩用~

[ 本帖最後由 飛飛 於 2008-8-7 23:12 編輯 ]

can not 正負極掉轉

This method cannot work!
Maybe demage your servo!

咁點攪好.....

You can try to instore the plastic servo arm up-side-down

sorry~唔係好明.....我英文唔好

Sorry!my writing board out of order.
I mean servo arm 有無位反轉裝,

咪跟車頭咁裝點樣反轉?

買個叫mixer的東東,可以隨時調轉,$80(for 直升機)

用 3 Ch 控 的 Programme Mixing 就得啦。按一下制便可將 2WS 轉 4WS。